specinvstr
10-02-2007, 11:23 AM
Need your feedback folks.
Some of you might recall that my brother had 3 of his SSR comps fixed. The lip on two of the rims were bent pretty significantly. The shop did not provide any advice, simply stated we can fix 'em. Well 2 months later, one lip formed a crack and the other bent. No pot hole/curb or anything was hit. Could this happen from cooking the rims too much? It was too late to stop the job when I received warning from this board stating that some bends should not be fixed. :( Just got off the phone with the shop and they said they only heat to 300 to fix and 420 with powdercoating. Of course they said bends/cracks not covered. Any feedback would be appreciated. My brother would have bought new rims if he new this would happen.:mad:
Some of you might recall that my brother had 3 of his SSR comps fixed. The lip on two of the rims were bent pretty significantly. The shop did not provide any advice, simply stated we can fix 'em. Well 2 months later, one lip formed a crack and the other bent. No pot hole/curb or anything was hit. Could this happen from cooking the rims too much? It was too late to stop the job when I received warning from this board stating that some bends should not be fixed. :( Just got off the phone with the shop and they said they only heat to 300 to fix and 420 with powdercoating. Of course they said bends/cracks not covered. Any feedback would be appreciated. My brother would have bought new rims if he new this would happen.:mad: